This is an initial attempt at creating a basic JeVois camera module mounting plate that will fit common tripods and 1/4" UNC bolt fixings.
I used the mounting pattern from http://jevois.org/doc/CaseMounting.html - the official documentation state that the JeVois case mounting holes are spec'd for M2.5/2-56 screws, but I found that M2 screws had the right diameter to bite the plastic without being over-tight. I'd recommend M2x6 screws to account for the 1mm countersink in the plate - I also used an M2 washer on each screw.
The UNC nut fitting is tight but does require a small dab of superglue to retain it. The OpenSCAD file is included if you need to make tolerance tweaks for your printer.